Table of Contents
Advertisement
FM INDOOR ANTENNA
H E D
-l
--1
-!
F M O U T D O O R A N T E N N A
NTABLE CONNECTION
:re tuintable is equipped with a moving-magnet type
:idge, connect its output cords to the PHONO MAG
rminais on the rear of the unit. If the turntable has a
bal ca'tridge, connect it to the AUX 1 terminals.
nect the left channel cord to the upper terminal, the
b to the lower. If the cartridge is of monophonic type,
:r terminal will do.
:cond turntable with magnet type cartridge is to be
l, conoect its cords to the PHONO MAG 2 terminals.
turntable with a moving-coil (MC) cartridge is to be
l, either a matching transformer for MC cartridge or
rate head amplifier must be employed.
Le turntable output cord plugs do not match the
rinals of this unit. In such a case, replace the plugs
L the spares provided in the accessories bag.
PI()NEER
TAPE DECK (RECORDER)
CONNECTION
. A
tape deck connected to this unit
must have a
record/playback preamplifier built-in. PIONEER's models
T-600
and T-500
feature characteristics ideally suited
to the SX-9000.
o The connected tape recorder should also have output
terminals for tape recorder connection (LINE OUT) or
tape monitor terminals.
C O N N E C T I O N F O R T A P E R E C O R D I N G
Connect this unit's TAPE REC terminals to the signal input
(LINE IN) terminals of the tape deck. Use the cords
provided with the deck. The upper terminal is for the left
channel, the lower for the right. If the tape deck is of
monophonic type, use the CENTER CHANNEL output
terminal instead.
C O N N E C T I O N F O R T A P E P L A Y B A C K ( O R M O N I T O R )
Connect the LINE OUT or TAPE MONITOR terminals on
the tape deck to the TAPE MON terminals on this unit.
Connection is done in the same way as described in the
above paragraph.
U S E O F R E C O R D / P L A Y B A C K C O N N E C T O R
The tape deck has a DIN type record/playback connector,
all recording and playback connections can be made by
means of this one (optional) cord. Plug one end into the
TAPE REC/P.B. connector on this unit and the other into
the corresponding connector on the tape deck. In this case
no other connection cords are necessary.
C O N N E C T I O N F O R M I X E D R E C O R D I N G
Connect the tape deck input terminals and this unit's PRE
OUT & MIXING REC terminals. Connection is made in the
same way as outlined above.
C O N N E C T I O N W H E N U S I N G T W O T A P E D E C K S ( R E -
C O R D E R S )
When using two tape decks, for example, when you wish to
edit an already-recorded tape or practice along with a
recorded concert, etc., and then hear the results, connect
the second tape deck to the TAPE MON B and TAPE REC
B jacks on the front of the SX-9000. These jacks take 1/4"
standard phone plugs.
Hide quick links:
Advertisement
Table of Contents
