Table of Contents
Advertisement
Windows XP Installation
1.
Connect the rectangular end of the USB cable
into the USB host port of your computer, and
the square end into the USB port of your
network adapter. Windows XP will detect
the new device and prompt you to insert the
network device driver. Insert the device driver
into the CD-ROM drive of your system,
select Install the software automatically
(Recommended) and click Next to continue.
2.
Windows will start searching for the
appropriate driver for the installation. When
the screen appears as below, click Continue
Anyway to proceed.
3.
Wait for seconds while Windows copies the
appropriate driver to your system.
4.
Click Finish to complete the software
installation.
5.
To verify if your network adapter exists in
your computer and well enabled, you can
perform the following steps.
6.
Go to Start, Control Panel, System,
Hardware and then Device Manager.
7.
Click
Network adapters to expand. If Intelligent
CAPI 2.0 driver, Intelligent USB adapter
and Intelligent ISDN WAN miniport are
found, that means your network adapter exists
and enabled. If not, consult your distributor
for technical support.
Intelligent
- 13 -
ISDN
Drivers
and
Advertisement
Table of Contents
