Setup; Hdd Jumper Locations; Master/Slave Settings - Toshiba MK4026GAX User Manual

SETUP – MK4026GAX (HDD2193)
Caution: Your Hard Disk Drive is a precision device and even a small drop onto any surface can
cause damage. Electronstatic discharge can also damage the drive. You should ground yourself
prior to handling the drive.

Master/Slave Settings

Your Toshiba Hard Disk Drive can be configured as either a "Master" or "Slave" unit. Master
configuration is used for all single drive applications, and master or slave configuration (only one of each
per port) is used for two drive applications. Use the information in the following table before setting drive
as Master or Slave.
Master configuration is obtained by setting jumpers A, B, C & D open (no jumper present). Slave
configuration is obtained by setting jumpers C-D. When B-D jumper is installed, the drive is configured
as cable select. If pin 28 = Low, the drive is "Master", if pin 28 - High, the drive is "Slave".
2
Figure 1.HDD Jumper Locations
JUMPER
No Jumper
C-D Jumper
B-D Jumper
B-D Jumper
Prohibit A-B Jumper
Prohibit A-C Jumper
P28 DRIVE
- Master Drive
- Slave Drive
LOW Master Drive
HIGH Slave Drive
- -
- -