HP nw9440 Maintenance And Service Manual page 119

3. Remove the Torx8 T8M2.5×9.0 screw 1 that secures the
optical drive to the computer.
4. Use a flat-bladed tool to push the metal tab 2 toward
the right side of the computer. (The optical drive partially
removes from the optical drive bay.)
5. Slide the optical drive 3 out of the computer.
6. Remove the optical drive.
Removing the Optical Drive
7. If it is necessary to replace the optical drive bracket, remove
the two Phillips PM2.0×4.0 screws 1 that secure the bracket
to the optical drive.
8. Remove the optical drive bracket 2.
Removing the Optical Drive
Reverse the above procedure to install an optical drive.
Maintenance and Service Guide
Removal and Replacement Procedures
5–19