Setting Channel Skip - Toshiba 19SLV411U Owner's Manual

Note:
• You must configure the ANT/CABLE input source
before programming channels ( page 26).
• The automatic channel programming process
will erase channels that were previously
programmed into the TV's memory.
• To tune the TV to a channel not programmed in
the channel memory, you must use the Channel
Number buttons on the remote control.
• Programming channels when the ANT/CABLE
input is configured for Cable will take
substantially longer than when the antenna
input is configured for Antenna. This is
normal; however, once channel programming
is finished, you should not have to repeat
the programming process again unless your
Cable TV service lineup changes significantly.
To program channels automatically:
1
Configure the antenna input source, if you have
not already done so ( page 26).
2
and open the Setup menu.
Press
3
Highlight Installation and press
4
A new set of Installation menu icons will appear,
as shown below. Open the Terrestrial menu,
highlight Channel Program to bring up the
Start Scan, and press
programming.
The TV will automatically cycle through all the
antenna channels, and store all active channels
in the channel memory. While the TV is cycling
through the channels, the message "Scanning
channels, please wait" will appear.
Chapter 5: Setting up your TV
.
again to begin channel
5
To cancel channel programming, press
control (or highlight Cancel in the on-screen display and
press ).
When channel programming is finished, press
to view the programmed channels.

Setting channel skip

To prevent certain channels from being viewed,
channel positions can be skipped.
1
From the Setup menu, highlight Installation and
press .
2 Press S or T to select Channel Options and press
. The list of channels will appear.
3 Press S or T to select a channel position to be
skipped and press . A tick will appear in the
box. To remove the tick, press
To add a channel to the channel memory:
Highlight the checked box next to the channel number
you want to add, and then press
To block channels in the channel memory:
You can block specific channels. You will not be able to
tune blocked channels unless you unlock them.
1 From the Channel Options menu, press Xto move
to the channel lock list.
2
Press S or T to select a channel position to
be locked and then press
digit PIN code. A tick will appear in the box. To
remove the tick, press
Note: If the PIN code has not been set yet, a
warning message will appear.
3
To save the setting, press
on the remote
or
again.
to remove the tick.
. Enter your four-
again.
.
(continued)
27