Central Pneumatic 94667 Operating Instructions Manual page 6

2. If necessary, add a premium quality, 30-weight, non-detergent compressor oil
into the Oil Fill Hole until the level of oil reaches the maximum level as indicated
on the Oil Window (20B). The optimal capacity of the oil reservoir is 30 ounces.
Do not overfill. Then thread the Breather Valve back into the Oil Fill Hole, being
careful not to strip the plastic threads.
Front Cover (18b)
oil Window (20b)
To Turn The Air Compressor On:
1. Check to make sure the Water Drain Valve (10A) is fully closed.
2. Turn the Air Flow Valve (6A) to its "OFF" position.
3. Connect the air hose (not provided) to the Air Flow Valve (6A) of the Air
Compressor. Then, connect the other end of the air hose to the pneumatic tool
(not provided) that is to be used.
4. note: always plug the Power Cord of the air Compressor into a 115 V~
electrical source (±10% maximum variation).
5. Rotate the "ON/OFF" Power Switch (1A) to the horizontal position to turn the Air
Compressor on. (Rotate the "ON/OFF" Power Switch (1A) to the vertical position
to turn the Air Compressor off.)
6. Allow sufficient time for the Tank Pressure Gauge (4A) to indicate 80 PsI before
using the Air Compressor.
7. Turn the Air Flow Valve (6A) to its "ON" position to allow air to the pneumatic tool.
SKU 94667 For technical questions, please call 1-800-444-3353.
(see Figure C, and assy. diagram b.)
breather Valve (14b)
FIGurE C
PAGE 6