Cable Your Access Point; Verify The Cabling - NETGEAR WNDR4300-TN User Manual

N750 Wireless Dual Band Gigabit Access Point WNDR4300-TN

Cable Your Access Point


To cable your access point:
1. Connect the Ethernet cable to your gateway.
2. Connect the other end of the Ethernet cable to one of the LAN ports on the access point.
3. Plug the power adapter into an electrical outlet.
4. Plug the other end of the power cable into the access point.

Verify the Cabling

Verify that your access point is cabled correctly by checking the access point LEDs. Turn on
the access point by pressing the On/Off button on the back.
• The Power LED lights amber when the access point is turned on.
• The LAN port LEDs light green for each computer cabled to the access point.
• The 2.4 GHz LED is lit, and the 5.0 GHz LED is lit.
Verify that the LAN
point by an Ethernet cable.
Note: The preset SSID (WiFi network name) and preset WiFi password for
your access point are unique. This information is on the label on
your access point.
LEDs (1 through 4) are lit for any computers cabled to the access
Hardware Setup
10