Table of Contents
Advertisement
If you encounter any trouble to boot you system, follow the
procedures accordingly to resolve the problem.
Start
Turn off the power and unplug the AC power cable, then remove all of
the addon cards and cables, including VGA, IDE, FDD, COM1, COM2
and Printer..
Make sure if the jumper settings for CPU and DRAMs are correct.
Clear CMOS.
Install the VGA card. Then connect your monitor and keyboard.
Turn on the power, and check if the power supply and
CPU fan work properly.
Yes
Check if there is display.
Yes
Press Ctrl, and Alt key at the same time, hold them and then
press Del to see if the system reboots.
Yes
During system rebooting, press Del to enter BIOS Setup. Choose
"Load Setup Default".
Turn off the system and re-connect the IDE cable.
Check if the system can reboot successfully.
Yes
Re-install Windows 95, Windows 98 or Windows NT.
End
No
The problem was probably caused by
power supply or motherboard failure.
Please contact your reseller or local
distributor for repairing.
No
Perhaps your VGA card or monitor is
defective.
No
It is very possible that your keyboard is
defective.
No
The problem should be caused by the
IDE cables or HDD itself.
Part Number and Serial Number
The Part Number and Serial number are printed on bar code label. You can find this
bar code label on the outside packing, on ISA/CPU slot or on component side of
PCB. For example:
P/N: 91.88110.201 is part number, S/N: 91949378KN73 is serial number.
Model name and BIOS version
Model name and BIOS version can be found on upper left corner of first boot screen
(POST screen). For example:
AX64 R1.20 Jan.04.2000 AOpen Inc.
Award Plug and Play BIOS Extension v1.0A
Copyright © 1998, Award Software, Inc.
AX64 is model name of motherboard, R1.20 is BIOS version.
Advertisement
Table of Contents
