Guideline For Shift Lever Position - Jancy Engineering 17982 Operator's Manual

13. Maintain Tools with care
Keep tools sharp and clean for better and safer performance.
•
Follow instructions for lubricating and changing accessories.
•
Inspect tool cords periodically and if damaged, have repaired by authorized service facility.
•
Inspect extension cords periodically and replace if damaged.
•
Keep handles dry, clean, and free from oil and grease.
•
14. disconnect Tools
Unplug when not in use, before servicing, and when changing accessories, such as bits and cutters.
•
15. Remove Adjusting keys And wrenches
Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on.
•
16. Avoid Unintentional Starting
Do not carry a plugged-in tool. Always disconnect from power source before moving.
•
Be sure switches are off before connecting to a power source.
•
17. Outdoor Use Extension cords
When tool is used outdoors, use only extension cords intended for use outdoors and so marked.
•
18. Stay Alert
Watch what you are doing. Use common sense. Do not operate tool when you are tired.
•
Do not use when taking medications that may cause drowsiness.
•
19. check damaged Parts
Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine
•
that it will operate properly and perform its intended function.
Check alignment of moving parts, binding of parts, breakage of parts, mounting, and any other conditions
•
that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced
by an authorized service center.
Do not use this tool if switches do not turn it on and off. Have defective switches replaced by authorized
•
service center.
4
important safety instructions
guideline for 2x2 shift lever position