Installation Of Ccu In Rack; Installation Of A Channel Control Unit With A 1/2 19" Accessory; Fitting Of Accessory To The Left Of The Channel Control Unit - THOMSON TTV 1707 User Manual

Chapter 2 - Installation

Installation of ccu in rack

This chapter provides general information concerning installation of the equipment.
For a description of the various connectors, refer to the chapter specific to each
subassembly. The OCP40 /OCP42 panels are described in a specific manual.

2.1 - INSTALLATION OF CCU IN RACK

The DT500 CCU is fitted in a 19"rack:
1. Either alone or with an accessory of dimension 1/2 19" (vectorscope, oscilloscope,
etc.) using the assembly kit for CCU DT500 in 19" racks, part number
BDT050701AA.
2. Or two DT500 CCU's side by side using kit part number BDT05700AA.

2.1.1 - Installation of a Channel Control Unit with a 1/2 19" accessory

EQUIPMENT AND TOOLS REQUIRED
• Rack installation kit part number BDT05701AA containing various accessories,
• A screwdriver.

2.1.1.1 - Fitting of accessory to the left of the Channel Control Unit

1. Remove the LH lug from the CCU DT500 by unscrewing both attaching screws.
2. Couple the accessory rack to the LH side of the CCU DT500 with the lugs located at
the back of the CCU DT500.
B1707M00LD
September 2000
accessory rack
THOMSON TTV1707 / CCU DT500
125
User manual