Place grill into outdoor enclosure, but leave enough room in the back to
connect to the gas supply.
LP Gas Installation
1. Check that the LP gas pressure regulator/hose assembly is
positioned under the grill (as shown in the following illustration)
and is not pinched or kinked.
2. Use 2 screws and the 1-piece 90° clamp mounting bracket provided
to attach the 90° brass connector to the back of the enclosure. The
brass connector is located between the flexible gas hose and the LP
gas pressure/hose assembly.
A
B
A. 2 screws
B. 1 piece 90° clamp mounting bracket
13
Install Grill
Grease Cup Bracket Installation
1. Loosen and remove the 4 screws preassembled on the grease
cup bracket.
2. Attach the left and right grease cup bracket on firebox bottom
panel under side, align screw holes, insert 4 screws which moved
from step 1 into these screw holes. Screws lock from firebox
bottom panel under side.
3. Tighten these 4 screws.