Operating Sequence - Electrolux EW 643 F Installation And Instruction Manual

Operating sequence

1 Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a
time, shaking them out as much as possible.
Close the door.
2 Measure out the detergent
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent
recommended by the manufacturer in a
graduated cup and pour it into the main wash
compartment . If you wish to carry out a
prewash, pour detergent into the appropriate
compartment marked
3 Measure out the additives
If required, pour fabric softener into the
compartment marked
«MAX» mark.
4 Select the desired option(s)
5 Select the temperature
Turn the selector dial to the required
temperature setting.
6 Select the programme and start it
Turn the programme selector dial clockwise to
the required wash programme and press the
on/off button : the operating pilot light comes
on and the machine starts to operate.
7 At the end of the programme
The machine stops automatically, the operating
pilot light goes out.
If you have selected a gentle programme with
the anticrease option
opening the door.
It is normal to have to wait for about 2 minutes
before being able to open the door to allow the
safety lock to release.
Press the on/off button
14
.
without exceeding the
, drain the water before
again.
P1018
M0043S
Remove the laundry.
Turn the drum by hand to make sure it is completely
empty, so as to avoid any forgotten items being
damaged in a subsequent wash (e.g. shrinking) or
their colour running into a load of whites.
Release any buttons which have been pressed.
Turn the water tap off and unplug the machine.
Leave the door ajar to air the machine.
P1019
M0042
P0033