Zanussi ZBB24430SA User Manual page 11

Loosen the upper pin and
remove the spacer.
Remove the upper pin and
the upper door.
Remove the lower door.
Loosen the lower pin.
Ventilation requirements
The airflow behind the ap-
pliance must be sufficient.
Installing the appliance
Caution! Make sure that the mains cable can move
freely.
Do the following steps:
www.zanussi.com
Loosen the middle hinge.
On the opposite side:
Install the lower pin.
Install the lower door.
Install the upper door.
Tighten the spacer and the
upper pin.
5 cm
min. 200cm
min.
200cm
x
1
If necessary cut the
adhesive sealing strip and
then apply it to the appli-
ance as shown in figure.
4mm
44mm
2
3
Adjust the appliance in
the niche.
2
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
x
2
Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
I
I
4
Attach the appliance to
the niche with 4 screws.
2
1
11