Electrolux Praxio Z 6020 Instruction Book page 8

g
When you have finished cleaning,
remove the accessories in the reverse
order of fitting.
0 Push the button on the end of the hose
(J) to pull out the suction hose.
Clean the accessories and store in a dry
3
place.
If the dirty water tank (25) is full, the
suction will be interrupted by a safety
device.
0 Open the housing lid (5) and empty the
dirty water tank (25) (T).
Wet Cleaning Carpets and
Upholstery
1 Check that the P. Tex cleaning agent
delivered with your appliance is suita-
ble for cleaning your rugs, fitted car-
pets or upholstery. Do this by carrying
out a test on a part of the item that
cannot be seen.
To obtain the best results you should
only use the original cleaning agent.
Only clean carpets and upholstery that
1
are suitable for wet cleaning. Delicate,
hand-woven or non-colour-fast car-
pets may not be wet cleaned.
Prior to wet cleaning carpets or uphol-
3
stery, thoroughly vacuum the entire
area to remove loose dirt.
If the carpet has previously been sham-
pooed there might be considerable
build-up of foam in the dirty water
container when P. Tex is used for the
first time. To avoid more foam, add half
a cup of vinegar to the dirty water
tank.
If foam comes out of the air vent,
switch off the appliance immediately
and empty the dirty water tank (T).
Check that there is no dust bag in
1
the appliance.
0 Turn the suction elbow (8) to the "Wet"
position (S).
0 Close the housing lid again (D).
0 Remove the fresh water tank (2).
8
0 Fill the fresh water tank with water
and cleaning solution in the quantities
stated on the cleaning agent bottle.
1 litre of cleaning solution is sufficient
3
to clean approx. 6.5 m
2
8 m of hard floor.
Only use hand-hot water as higher
temperatures can damage the appli-
ance as well as the carpets and uphol-
stery.
0 Re-insert the filled fresh water tank
(2).
0 Connect the end of the hose to the
hose connector (6) (E).
0 Push the handle (21) into the suction
tube (20) and lock both pieces into
place.
0 Close the suction regulator on the han-
dle (22).
0 The accessories are attached to the end
of the suction tube (20):
• carpet spray extraction nozzle (13)
for wet cleaning rugs and carpets,
• upholstery spray extraction nozzle
(14) for wet cleaning upholstered
furnishings.
Only wet clean with the appliance
horizontal.
0 Press On/Off switch (4).
0 Press On/Off switch (9) for cleaning
pump (Y). This switches on the pump
and sends cleaning agent to the nozzle.
0 Using the electronic suction control (3)
you can set the required, continuously
variable, level of suction power (I).
0 To spray the cleaning agent, press the
spray dispensing button on the handle
(27).
To achieve the best possible cleaning
3
results proceed as follows:
1. When wet cleaning always pull the
carpet spray extraction nozzle (13)
towards yourself.
2. Finish cleaning as close as possible to
the door.
To avoid resoiling cleaned rugs or car-
3
pets, leave them to dry completely
before walking on them.
2
of carpet or