Automatic Switch Off; Automatic Heat Up; The Heat Setting; Power Function - Electrolux EHL6740FOK User Manual

www.electrolux.com
8

4.2 Automatic Switch Off

The function deactivates the
appliance automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
•
-
•
-
•

4.3 The heat setting

Touch the control bar at the heat setting.
Change clockwise or counterclockwise, if
it is necessary. Do not release before you
have a correct heat setting. The display
shows the heat setting.
comes on and the cooking zone
comes on and the appliance
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours
4.4 Bridge function
The Bridge function connects two cook-
ing zones and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the Bridge function for left/
right cooking zones touch
or change the heat setting touch one of
the left/right control sensors.
To deactivate the Bridge function touch
/ . The cooking zones operate in-
dependently.
When you use only one cooking zone of
the pair we recommend that you use the
rear cooking zone. Also when you use
large cookware we recommend that you
put it near to the rear cooking zone.

4.5 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch ( comes on in the dis-
play).
2. Immediately touch the necessary heat
setting. After 5 seconds
in the display.
To stop the function change the heat set-
ting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14

4.6 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
/ . To set
comes on