Page 12
PRE-AMP connector on the rear of lock-in. Both USING THE SR550 WITH THE SR510/530 ends of the cable are equivalent. If a longer The SR510/530 lock-ins sense the presence of...
Page 13
DYN RES FS Sensitivity SR552 Gain USING THE SR552 WITH SRS DSP LOCK-INS The SR552 is not sensed by the DSP lock-ins. > 50 mV The DSP lock-in does NOT compensate for the 20 db 50 mV gain of the preamp. The gain of the preamp is 20 mV set to 10.
Page 14
dual phase lock-in, use the R output to avoid All three voltages are required. Pins 7 and 8 phase shifts. should be tied together. All other pins should be left open. The gain will be 100 in this configuration. Grounding pin 3 will change the The SR552 without a lock-in gain to 50, and grounding pin 4 will change the The SR552 can be powered with an external...
Page 15
PARTS LIST REF. SRS part# VALUE DESCRIPTION 5-00040-509 1.0U Capacitor, Electrolytic, 50V, 20%, Rad 5-00030-520 2200U Capacitor, Electrolytic, 16V, 20%, Rad 2200U Capacitor, Electrolytic, 16V, 20%, Rad 5-00030-520 2.2U Capacitor, Tantalum, 35V, 20%, Rad 5-00100-517 2.2U Capacitor, Tantalum, 35V, 20%, Rad 5-00100-517 2.2U Capacitor, Tantalum, 35V, 20%, Rad...
Need help?
Do you have a question about the SR550 and is the answer not in the manual?
Questions and answers