Danby DAC080EB2GDB Owners Manual And Care Manual page 14

Service Questions: Contact Danby at 1 (800) 263-2629
Sales Inquiries: Contact Sylvane at (800) 934-9194 or visit sylvane.com
Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
SLEEP OPERATION
In this mode, the selected temperature will
increase (when in cooling mode) by 2°F one
half-hour after sleep mode has been selected.
The temperature will then increase by another
2°F after an additional half-hour.
This new temperature will be maintained for 6
hours before returning to the originally selected
temperature. This ends the Sleep mode and the
unit will continue to operate as originally prog-
1 rammed.
The Sleep mode program can be cancelled at
any time during operation by pressing the Sleep
button again.
TIMER OPERATION
Pressing the TIMER button can set the
Auto-start and Auto-stop time of the unit.
NOTE:
To set Auto-start time, the unit must be in
the OFF position.
To set Auto-stop time, the unit must be in
the ON postion.
To set the Auto-start time.
1. Push the TIMER button when the unit is
off; only the Auto-start feature can be set.
1
2. Keep pressing the TIMER button. Each
press will increase the selected time by
0.5 hour increments. When the selected time
has added up to 10 hours,each press will
increase the selected time by 1 hour
increments, up to 24 hours.
3. The time can be set in the range of 0 - 24
hours.
4. After the desired time has been selected, wait
for about 10 seconds, until the setting tempe-
rature reappears in the display window
of the air conditioner. This indicates that
the program has been set.
11