Table of Contents
Advertisement
Available languages
Available languages
A .
B .
C.
D.
E.
F.
CAPABILITIES
Will shred: Paper, credit cards, CD/DVDs, staples, paper clips and junk mail
Will not shred: Adhesive labels, transparencies, newspaper, cardboard, laminates, file
folders, X-rays or plastic other than noted above
Paper shred size:
Strip-Cut ........................................................................................... 5/32 in. (4mm)
Cross-Cut ........................................................ 5/32 in. x 1-9/16 in. (4mm x 40mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always set
to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
15
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder. Do not place
15
near or over heat source or water.
• Do not operate the machine without the safety shield closed (A).
15
BASIC SET UP
SHREDDER SET-UP
1
2
Place cutter head into
Open the door
top of cabinet, use 2
people
2
G.
H.
3
4
Make sure safety flap
Ensure access to a
dedicated 15Amp,
is securely in place
120V outlet
KEY
A. Safety Shield
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Basket (inside)
F. Casters
G. See safety instructions
Maximum:
Paper entry width .......................................................................... 10-1/4"(260mm)
8.5"x11", 20lb., (75g) paper at 120V, 60 Hz, 8Amps; heavier paper, humidity or other than
rated voltage may reduce capacity.
* In order to perform at capacity, shredder must be plugged into a dedicated 15Amp,
120V outlet.
• This shredder has a Disconnect Power Switch in the cabinet door. The door must
be fully closed to operate shredder. In case of emergency, open cabinet door. This
action will stop shredding immediately.
• Avoid touching exposed cutting blades under shredder head.
• Do not put foreign objects in paper entry.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with
this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
BASIC SHREDDING OPERATION
TO SHRED
1
2
Plug in and make
Press ( ) ON to
sure door is closed
activate
Models 3250C/3250S
H. Control Panel and LEDs
1. ON/OFF (blue)
R 2. Reverse (red)
3. Bin full (yellow)
4. Door open (red)
5. Safety Shield Open (red)
3
4
or
Feed paper straight
When finished
into paper entry and
shredding set to
release
( ) OFF
ENGLISH
5
Do nothing and shredder
will automatically shut
off after 30 minutes of
inactivity
Advertisement
Table of Contents
