Troubleshooting - Fellowes POWERSHRED DS-3 Instructions Manual

BASIC SHREDDING OPERATION
Continuous operation:
NOTE:
ADVANCED PRODUCT FEATURES
SAFESENSE ® TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
2
1
Turn the shredder ON
Touch test area and
( ) to activate
look for the SafeSense
SafeSense
indicator to illuminate
®
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 2
Press and hold Reverse
Alternate slowly back and forth
(R) 2-3 seconds
PAPER/CARD
2
1
Press Auto-On ( ) Feed into paper entry
and release
3
D S - 3
SafeSense is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off
3 4
Set to Off
and unplug
3
or
Feed into center of
entry and release
2 3
Press and hold Reverse
*Apply oil across entry
(R) 2-3 seconds
5 6
Gently pull uncut paper
Press and hold
from paper entry. Plug in. Reverse (R)
4
Set to Off
3