Hydraulic Oil - Cub Cadet Tank S S7237 Operator's Manual

8. To re-install the tank, reverse the above instructions
but make sure the alignment pin fits into the slot on the
bottom of the cylinder valve guard.
WARNING!
Be sure to check for leaks after
installing tank. Leaks must never be checked with a
flame. Always check for seal compromise with a
spray bottle filled with soapy water and look for
bubbles.
Air Cleaner
Service the pre-cleaner and cartridge/air cleaner element as
instructed in the Kawasaki Owner's Manual.
Spark Plug
The spark plugs should be cleaned and the gap reset once a
season. Refer to the Kawasaki Owner's Manual for correct plug
type and gap specifications.

Hydraulic Oil

WARNING!
Never overfill the hydraulic units.
Damage can occur if the oil level is not within the
proper operating range.
NOTE: When adding hydraulic oil, do so in small quantities and
recheck the oil level before adding more. It is important that you
do not overfill the reservoir.
Adding Hydraulic Oil (use SAE15W40)
1. Place the tractor on a level surface and engage the parking
brake.
2. Stop the engine and remove the key from the ignition
switch.
3. Raise the seat forward to expose the hydraulic oil fill point.
4. Clean the area around the hydraulic oil fill neck. See Fig.
6-3.
Hydraulic Oil
Tank Cap
Hydraulic
Oil Filter
Figure 6-3
5. Remove the hydraulic fill cap and check the level. See Fig.
6-3. The correct level is up to the lowest hole of the oil tank
fill neck.
Hydraulic Oil
Fill Neck
Hydraulic
Tank
6. Pour hydraulic oil into the reservoir a
fill neck and 1.5 ounces of Ornite additive, if necessary.
Hydraulic Oil Tank and Filter
NOTE: Used hydraulic oil must be disposed of properly. Do
not pour it down a drain or sewer, or dump it on open land,
this creates an environmental hazard. Please be aware of the
environment when disposing of used oil.
1. Place the tractor on a level surface and engage the parking
brake.
2. Stop the engine and remove the key from the ignition
switch.
3. Raise the seat forward to expose the hydraulic oil fill point.
4. Clean the area around the hydraulic fill oil cap.
5. Remove hydraulic fill oil cap.
6. Place a suitable container (at least 2 gallon) under the
hydraulic reservoir and filter.
7. Remove the two bolts securing the hydraulic filter and
allow the hydraulic oil to drain. Remove the drain plug from
the bottom of the hydraulic oil tank to drain. Replace the
plug. See Fig. 6-4.
Hydraulic
Oil Filter
Screw
Figure 6-4
8. Place a small pan under the pump motor frame. Remove fill
oil cap from hydraulic reservoir for faster drainage. Remove
nut caps and drain oil from both left and right pumps.
Replace and retighten nuts. See Fig. 6-4.
9. Remove the three screws from the top of the oil filter and
replace the oil filter element. Coat the sealing surface
with Shell Rimula 15W40 oil or equivalent. Install the three
screws back into the oil filter.
10. Add proper amount of hydraulic oil to reservoir and 1.5
ounces of Ornite additive.
11. Run and purge pumps and motors. Check oil level.
12. Add proper amount of hydraulic oil to reservoir and repeat
step 11.
NOTE: This unit is equipped with two traction drive pumps
and one pump for steering and implement lift.
NOTE: After unit is up to operating temperature, turn off
s 6 — M
ectiOn
1⁄4 " below the oil tank
Bolts
Oil
Drain
Plug
& a
aintenance djustMents
29