Auto Setup - Denon AVP-A1HD Owner's Manual

Auto Setup

Optimize settings for speakers in use.
F Menu tree F
Auto Setup
a Auto Setup
s Option
d Parameter Check
a Auto Setup
The settings are performed automatically.
GAuto Setup flowH
STEP1 Preparation
STEP2 Detection & Measurement (main)
STEP3 Measurement (2nd – 8th)
STEP4 Calculation
STEP5 Check
STEP6 Store
Finish

STEP1 Preparation
• Configure the following settings as required.
• To start Auto Setup without configuring the following settings,
perform step 4 only, and then proceed to step 2.
AVC-A1HD
n Amp Assign
vpage 14, 15
Select the method for using the power amplifier in accordance with
the connected speaker configuration.
Choose this when "Amp Assign" in the GUI menu is set to anything
other than "Normal".
vpage 16, 17
n Pre-out Assign
Change the pre-out terminal assignment.
n XLR Out Polarity
vpage 18
Set to switch the XLR pre-out terminal polarity.
n Channel Select
The measurement time can be shortened by selecting the speakers
vpage 18
to be measured in advance. Please set if necessary.
When measuring 2 or 3 subwoofers, configure the "Channel
Select" settings.
vpage 19
• "Front Height" is displayed when the "Amp Assign" – "Assign Mode"
setting (vpage 28) in the GUI menu and the "Extension Channel"
vpage 19
setting (vpage 28, 29) are set to "Front Height".
• "Front Wide" is displayed when the "Amp Assign" – "Assign Mode"
setting (vpage 28) in the GUI menu and the "Extension Channel"
setting (vpage 28, 29) are set to "Front Wide".
vpage 20
AVP-A1HD
AVP-A1HD
AVC-A1HD AVP-A1HD