Technical Specifications - HP LP1965 Specification

QuickSpecs

Technical Specifications

Panel
Video/Other Inputs
Signal Interface/
Performance
Type
Viewable Image Area
(diagonal)
Screen Opening (WxH) 14.9 x 12.0 in (38.0 x 30.5 cm)
Viewing Angle (typical)*178 degrees horizontal/178 degrees vertical (10:1 minimum contrast
Brightness (typical)*
Contrast Ratio (typical)* 1000:1 (typical)
Response Time
(typical)*
Pixel Pitch
Color Depth Support
Backlight Lamp Life
(to half brightness)
* NOTE: All performance specifications represent the typical specifications provided by HP's
component manufacturers; actual performance may vary either higher or lower.
**NOTE: 20 ms rise and fall
Plug and Play
Self Powered USB 2.0
Hub
Input Signal
Input Impedance
Sync Input
Video Cable
Video Cable Length
Horizontal Frequency 24 to 83 kHz
Vertical Frequency
Native Resolution
Maximum Resolution
(Analog)
Maximum Resolution
(Digital)
Preset VESA Graphic
Modes (non-interlaced)
Preset MAC Mode
Preset VGA Mode
Preset SUN Mode
Fail Safe Mode
Maximum Pixel Clock
Speed
DA - 12620 Worldwide QuickSpecs — Version 2 — 11.1.2006
Active matrix, thin film transistor (TFT)
19 in (48.25 cm) maximum viewable
ratio)
2
300 nits (cd/m )
6 ms (typical gray to gray)**
0.294 mm
16.7 million colors
50K hours
Yes (supports VESA DDC2B and DDC/CI; PC2001 compliant)
One upstream, four downstream ports (cable included)
Two DVI-I connectors (VGA analog or digital)
75 ohms ± 2%
Separate sync (HSYNC/VSYNC); composite sync, Sync on Green
(activated through on-screen display)
One DVI-D to DVI-D, and 1 DVI-I to VGA cables
71 in (1.8 m)
48 to 76 Hz
1280 x 1024 @ 75 Hz analog
1280 x 1024 @ 60 Hz digital
1280 x 1024 @ 75 Hz analog
1280 x 1024 @ 75 Hz digital
640 x 480 @ 60 Hz, 72 Hz, 75 Hz
720 x 400 @ 70 Hz
800 x 600 @ 60 Hz, 72 Hz, 75 Hz
1024 x 768 @ 60 Hz, 70 Hz, 75 Hz
1280 x 1024 @ 60 Hz, 75 Hz
832 x 624 @ 75 Hz
1152 x 870 @75 Hz
640 x 480 @ 60 Hz, 72 Hz
1152 x 900 @ 76 Hz
Yes (limits out of range signal messages)
140 MHz
HP LP1965 Flat Panel Monitor
Page 2