JL Audio Fathom IWS-SYS-2 Owner's Manual page 20

PROCESSOR (BALANCED OUTPUTS)
OUTPUTS
WARNING! TURN OFF THE Fathom IWS AND ALL OTHER EQUIPMENT IN
THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
Page 20
RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
FRONT
OR
FRONT
FATHOM REAR CONTROLS (MASTER)
PRE OUT
REAR CENTER
L
R REAR SUB
SYSTEM CONNECTION DIAGRAM 1:
One Fathom IWS to
Home Theater Receiver or
Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer output. When
connecting a mono subwoofer output
to your Fathom IWS, you will only use the
Fathom IWS's "Left or Mono" input.
Two connection types are available
for connecting the Fathom IWS to your
home theater system: balanced (XLR or
1/4-inch TRS connector) and unbalanced
(RCA-type connector). Balanced
connections provide superior noise
rejection and ensure proper grounding
between components. If your receiver or
processor has balanced outputs, we highly
recommend that you use them.
In the connection diagram at left,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
WARNING
| Fathom IWS