Nikon COOLPIX P340 Quick Start Manual page 269

Problem
• The camera automatically turns off to save power
Camera turns off • The camera or battery has become too cold and
without
warning. • The inside of the camera has become hot. Leave the
• The camera is off.
• The battery is exhausted.
• The camera has entered standby mode to save
• The flash lamp flashes while the flash is charging.
The monitor is
blank.
• The camera and computer are connected via a USB
• The camera and TV are connected via an HDMI cable.
• Interval timer shooting in progress.
• Wi-Fi is connected.
• Adjust the monitor brightness.
Monitor is hard
to see.
• The monitor is dirty. Clean the monitor.
• If the camera clock has not been set, the "Date not
Date and time of
recording are
not correct.
• The camera clock is not as accurate as ordinary
No information
Hide info is selected for Photo info of Monitor
displayed in
settings in the setup menu.
monitor.
Print date not Time zone and date has not been set in the setup
available. menu.
Cause/Solution
(auto off function).
cannot operate properly.
camera off until the inside of the camera has cooled,
and then try turning it on again.
power. Press the power switch, shutter-release
button, c button or b (e movie-record) button,
or rotate the mode dial.
Wait for the flash to charge.
cable.
set" indicator flashes during shooting and movie
recording. Images and movies saved before the clock
is set are dated "00/00/0000 00:00" or "01/01/2014
00:00" respectively. Set the correct time and date
from the Time zone and date option in the setup
menu.
watches or clocks. Periodically compare the time of
the camera clock with that of a more accurate
timepiece and reset as required.
A
23
F3
–
22
22
23
54
97,
101
97,
E15
E37
95,
E63
92,
E68
F6
24, 92,
E66
92,
E66
92,
E68
24, 92,
E66
F9