Changing The Uv Lamp - SCI EdenPURE G-7 Owner's Manual

GENERAL MAINTENANCE
UNPLUG THE UNIT BEFORE PERFORMING ANY MAINTENANCE PROCEDURES

CHANGING THE UV LAMP

1. Unplug the power to the unit.
2. Remove the Primary filter and the Purification Plate. Refer to page 5.
3. Remove the tape on either end of the UV Lamp if it is present.
4. Place one finger from each hand (middle or index) on the metal ends of the UV
Lamp. Very carefully apply just enough pressure to roll the lamp (preferably
towards the back of the unit) until it is loose. Note: The reflective metal shield
behind the UV Lamp has a sharp edge. Be careful not to cut yourself,
especially if you roll the UV Lamp forward.
5. Remove the old UV Lamp and insert the new one by aligning the end pins to slide
into the end sockets (just like a standard fluorescent bulb).
6. Once both sets of end pins are in their slots, place one finger from each hand
(middle or index) on the metal ends of the UV Lamp. Very carefully apply just
enough pressure to roll the lamp (preferably towards the back of the unit) until it is
secure on both ends. Note: The reflective metal shield behind the UV Lamp
has a sharp edge. Be careful not to cut yourself, especially if you roll the UV
Lamp forward.
7. Carefully reinsert the Purification Plate into its original position.
8. Place the Primary filter back in its original position and re-install the four corner screws.
9. Plug the power cord back into the unit and turn it on. Confirm the new UV Lamp is
functioning properly. If it is not working properly, repeat steps 1, 2, and 6. Test the
UV Lamp again.
CONTINUED
7