General Maintenance; Cleaning; Removal - SCI EdenPURE G-7 Owner's Manual

UNPLUG THE UNIT BEFORE PERFORMING ANY MAINTENANCE PROCEDURES
Recommended Monthly Maintenance
• Clean the Primary Filter
• Clean the Purifier Plate
• Clean the Catalytic Screen
PRIMARY FILTER & CATALYTIC SCREEN CLEANING
You have three options to clean the Primary filter and the Catalytic Screen:
1. When visibly dirty or after 30 days, remove the primary filter and the catalytic screen
from the unit. With a hand-held vacuum, remove the heavy particulate from both
filters. This method will extend the life of the filters and ensure proper function of the
catalytic screen.
2. If vacuuming does not clean the filter sufficiently, remove the primary filter and the
catalytic screen from the unit and wash them in warm water. Brush gently with a
toothbrush to remove particulate. Allow to dry thoroughly before re-installing.
NOTE: Do not use soap because it could damage the filters.
3. Replace the filter and/or catalytic screen. Contact the dealer you purchased your
product from or visit www.rppurchase.com to locate your closest dealer.
CLEANING THE PURIFICATION PLATE
1. Remove the Purification Plate (see Purification Plate and Catalytic Screen Removal).
2. Wash the Purification Plate with about 1 drop of mild dish soap (per side) and a toothbrush.
3. Use the toothbrush to make small circular motions over all of the metal mesh areas.
Be careful not to drop or break the Purification Plate while cleaning.
4. Rinse with water and allow it to air dry completely before reinstalling.
PRIMARY FILTER REMOVAL
1. Unplug the power to the unit
2. Unscrew the four rear corner screws from the Primary filter and pull the filter handle
to remove. Refer to Diagram A
3. After servicing Primary filter place it back in its original position and re-install the
four corner screws.
PURIFICATION PLATE AND CATALYTIC SCREEN REMOVAL
1. Remove Primary filter first.
2. Carefully remove the Purification Plate by lifting it straight up and then turn at an
angle to pull it out. This is an ideal time to clean the Purification Plate. Refer to
Diagram B.
3. Gently pull the Catalytic Screen handle to remove it for cleaning. Refer to Diagram C.
4. After servicing Catalytic Screen, place it back in its original position by placing the
bottom of screen in first. The bottom of the Catalytic Screen frame has raised place
holders. The place holders need to be reinserted into their original place. The
Screen should be secure and not move when installed properly.
5. Carefully reinsert the Purification Plate into its original position.
6. Place the Primary filter back in its original position and re-install the four corner screws.

GENERAL MAINTENANCE

5