Table of Contents
Advertisement
•i
INSTRUCTIONS FOR MODEL 20 81451 FOR USE WITH
CLEANMORE HOME CLEANING SYSTEM UPHOLSTERY NOZZLE
CAUTION - READ BEFORE USING
1. Follow the furniture manufacturer's recommendations for cleaning.
2. Do not use the Cleanmore Home Cleaning System to clean upholstery that should be dry
cleaned only. The label on recently manufactured furniture may be marked with the letter S
if the fabric should be dry cleaned.
3. Always test the fabric in an inconspicuous area to be sure that it is colorfast, does not
shrink and is not damaged by the rubbing action of the nozzle.
4. To prevent fabric staining and damage to internal materials, DO NOT SOAK FABRIC. If
fabric is heavily soiled and requires more than two passes with the cleaning solution, allow
fabric to dry completely. After drying, clean area again at a right angle to the original clean-
ing stroke.
5. If cleaning solution "pools" on fabric, discontinue use to avoid damaging the internal por-
tions of upholstered furniture.
ASSEMBLY AND FILLING
1. Assemble solution tank, recovery tank and hoses as you
would for carpet cleaning. Do not assemble straight
wands or floor nozzle.
2. Assemble upholstery nozzle directly to curved wand. Be
sure locking button snaps into hole in nozzle.
3. Slide spray body on underside of nozzle toward the
threaded portion of the curved wand and tighten nut.
(Figure 1).
4. Fill solution tank with hot tap water as you would for
carpet cleaning.
5. Add Sears Formula 4 (Number 20-8984) Upholstery
Cleaning Solution. Follow directions on bottle for mix-
ing solution. CAUTION -
USE ONLY SEARS 20-8984
CLEANING SOLUTION OR UPHOLSTERY DAMAGE
MAY OCCUR.
OPERATING INSTRUCTIONS
1. Use your household
vacuum cleaner to vacuum
upholstery thoroughly to remove all loose dirt.
2. Place the upholstery nozzle on the surface to be clean-
ed. Keep the slotted intake flat against the fabric at all
times. (Figure 2).
3. Pull the spray trigger and pull the nozzle toward you.
Clean a small area at a time, using short slightly overlap-
ping strokes. Additional strokes with vacuum only
without solution will help to dry fabric.
4. To retain the clean "see through" appearance of the noz-
zle, wash with lukewarm dish detergent solution and
rinse after each cleaning task.
CLEANING HINTS
1. To clean fabric welts (seams or cording) cleaning stroke should be parallel to the welt. Depress to flatten welt.
Thoroughly vacuum on both sides of welt to remove excess moisture.
2. Metal buttons can rust and stain fabric. After cleaning, dry buttons thoroughly, including underside, with a
white towel or cloth.
3. If you get any wooden parts wet, wipe dry at once. The use of a good furniture polish is recommended for care
of the wood.
4. If the upholstery fabric was previously treated with a stain repellant it should be retreated after the fabric has
been cleaned and is completely dry.
5. OTHER USES FOR UPHOLSTERY NOZZLE. The upholstery nozzle may also be used to clean car upholstery or
carpeting. In addition, the nozzle may also be used to clean carpeted stairs and other areas difficult to clean
with the normal floor nozzle.
(0485)
Pt. No. 660300-046
Advertisement
Table of Contents
