Set The Copy Quantity; Exposure Adjustment/Photo Copying; Stream Feeding Mode - Sharp AL-1552 Operation Manual

Stream feeding mode

The stream feeding mode allows easy operation of continuous copying from the SPF/
RSPF. If the stream feeding mode has been enabled using user program No.4, the
SPF/RSPF ( ) indicator will blink approximately 5 seconds after the last original has
been fed by the SPF/RSPF. While this indicator is blinking, any new originals placed in
the original feeder tray will be fed and copied automatically. If the stream feeding
mode has been disabled, the start (
are set even immediately after completion of a copy run from the SPF/RSPF. The
default setting of the stream feeding mode is "ON". See "USER PROGRAMS" (p.55).

SET THE COPY QUANTITY

Set the number of copies using the two copy quantity (
from the original table or copying from SPF/RSPF.
• Press the clear (
• A single copy can be made with the initial setting, i.e., when "0" is
displayed.
• Press the right copy quantity key to set the unit digit
from 0 to 9. This key will not change the tens digit.
• Press the left copy quantity key to set the tens digit
from 1 to 9.

EXPOSURE ADJUSTMENT/PHOTO COPYING

Exposure adjustment
Copy density adjustment is not required for most originals in the automatic exposure
mode. To adjust the copy density manually or to copy photographs, the exposure
level can be adjusted in two steps manually.
The copy resolution used for AUTO and MANUAL (
changed. (p.55)
1
Press the exposure mode selector key to
select the MANUAL (
PHOTO (
2
Use the light (
adjust the exposure level. If exposure level
2 is selected, the two left-handmost
indicators for that level will light up
simultaneously. Also, if level 4 is selected,
the two right-handmost indicators for that
level will light up simultaneously.
) key must be pressed each time the originals
) key to clear an entry if a mistake is made.
) mode or
) mode.
) and dark (
, ) keys when copying
Tens digit
) keys to
Unit digit
) mode can be
5
49