Maintenance; Maintenance Schedule - Lennox Crestline LSBV-3628MN Care And Operation Instructions Manual

Crestline series b-vent gas fireplaces 36"/42" lsbv models
Table of Contents

Advertisement

LENNOX CRESTLINE™ SERIES B-VENT GAS FIREPLACES • 36"/42" LSBV MODELS • CARE AND OPERATION INSTRUCTIONS

Maintenance Schedule

Annually (Before the onset of the Burning Season)
Maintenance Task
Inspecting/Cleaning Burner, Logs
and Controls
Check Flame Patterns and Flame Height
Inspecting/Cleaning Pilot and Burner
Checking Vent System
Appliance Checkout
Replacing Glowing Ember (Rockwool)
Materials
Periodically (After the Burning Season)
Maintenance Task
Cleaning Firebox Interior
Check Flame Patterns and Flame Height
Checking Vent System
Cleaning Optional Glass Doors
6
Accomplishing Person
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Services Technician
Accomplishing Person
Homeowner
Homeowner
Homeowner
Homeowner
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Procedure
Inspect valve and ensure it is properly operat-
ing. Check piping for leaks. Vacuum the control
compartment, fireplace logs and burner area.
Refer to Figure 8 on page 8 and verify the
flame pattern and height displayed by the
appliance conforms to the picture. Flames
must not impinge on the logs.
Refer to Figure 9 on page 8. Remove any
surface build-up on pilot and burner assembly.
Wipe the pilot nozzles, ignitor/flame rod and
hood. Ensure the pilot flame engulfs the flame
sensor as shown.
Inspect the vent system at the top and at the
base (within the firebox) for signs of blockage
or obstruction. Look for any signs of disloca-
tion of the vent components.
Perform the appropriate appliance checkout
procedure detailed in this manual.
Remove old ember materials and vacuum
the area for placement of glowing embers
(rockwool). Place new rockwool as described
in this document.
Procedure
Carefully remove logs, glowing embers (rock-
wool), and volcanic stone, if used. Vacuum
interior of the firebox. Clean firebox walls
and log grate. Replace logs, glowing embers
(rockwool), and volcanic stone, as detailed in
this manual.
Refer to Figure 8 on page 8 and verify the
flame pattern and height displayed by the ap-
pliance conforms to the picture. Flames must
not impinge on the logs.
Inspect the vent system at the top and at the
base (within the firebox) for signs of blockage
or obstruction. Look for any signs of dislocation
of the vent components.
Clean as necessary following the directions
provided in this manual. DO NOT TOUCH OR
ATTEMPT TO CLEAN DOORS WHILE THEy
ARE HOT.

Advertisement

Table of Contents
loading

Table of Contents