Cisco Aironet 1240AG Series Hardware Installation Manual page 41

Chapter 2 Installing the Access Point
The bracket mounting clip requires the use of two mounting clip holes on the mounting plate (see
Figure
Figure 2-6
1
Bracket mounting clip holes
Follow these steps to mount the access point above a suspended ceiling.
Insert the bracket mounting clip's tab into the large hole on the access point mounting plate.
Step 1
Place the clip over the T-bar box hanger and secure it to the access point mounting plate (see
Step 2
with the 1/4-20 fastener (supplied with the T-bar hanger).
Figure 2-7
Note
OL-8371-05
2-6).
Mounting Plate Holes
Access Point Mounting Plate
The illustration shows the access point mounting plate mounted perpendicular to the T-bar box
hanger. You can also mount the bracket parallel to the T-bar box hanger.
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
Mounting Above a Suspended Ceiling
Figure 2-7)
2-13