Configuring The Access Point System Power Settings Using A Browser - Cisco Aironet 1240AG Series Hardware Installation Manual

Chapter 3 Troubleshooting 1240AG Series Autonomous Access Points

Configuring the Access Point System Power Settings Using a Browser

You can also use your browser to set the access point System Power Settings.
Note The access point web-browser interface is fully compatible with Microsoft Internet Explorer version 6.0
on Windows 98 and 2000 platforms and with Netscape version 7.0 on Windows 98, Windows 2000, and
Solaris platforms.
Note When using the access point browser interface, you should disable your browser pop-up blocker.
Figure 3-2
Figure 3-2
Caution If the access point receives power through PoE, the output current of the power sourcing equipment
(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE802.3af or IEC60950
for limited power sources.
Table 3-3
power options.
Table 3-3 Access Point System Power Settings and Cisco Switch Commands
Power Source
AC power module
Cisco switch that supports
Intelligent Power Management
Cisco switch that does not
support Intelligent Power
1
Management
OL-8371-05
shows the system power setting options and indicates the power status of the access point.
System Power Settings
lists the access point system power settings and the Cisco switch power commands for several
Access Point System Power Settings
Configuration changes are not required
Power Settings:
1
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Pre-standard Compatibility (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
Low Power Condition
Cisco Switch
Power Command
power inline never
power inline auto
power inline auto
3-11