Cisco 1712 Hardware Installation Manual page 8

Security access routers
Hide thumbs Also See for 1712:
Table of Contents

Advertisement

Connecting Power to the Router
This product relies on the building's installation for short-circuit (overcurrent)
Warning
protection. Ensure that a fuse or circuit breaker no larger than 120VAC, 15AU.S.
(240VAC, 16A international) is used on the phase conductors (all
current-carrying conductors).
This equipment is intended to be grounded. Ensure that the host is connected to
Warning
earth ground during normal use.
Follow these steps to connect power to the router and to turn the router on:
Connect the attached power-supply cord to the power socket (labeled +5, +12,
Step 1
-12 VDC) on the router rear panel, as shown in
Cisco 1711 and Cisco 1712 Security Access Routers Hardware Installation Guide
2-8
Chapter 2
Installation
Figure 2-4 on page
2-9.
OL-4050-02

Advertisement

Table of Contents
loading

This manual is also suitable for:

1711

Table of Contents