Assembly - Gravely 985114 - 16 HP Owner's/Operator's Manual

TOOLS REQUIRED
Phillips Screwdriver, Needle Nose Pliers, Open-End
Wrench: 3/8, 7/16, 9/16 & 3/4 and or Adjustable
Wrench
REMOVE UNIT FROM CARTON
Remove the unit and components from the shipping
container.
Fwd-Rev
Control
Rod
Handlebar

Assembly

Optional
Brake Handle
Assembly
Figure 1
ASSEMBLY
2
3
4
1
1. Ignition Switch
Harness
2. Ignition Switch
Figure 2
ASSEMBLY
Hi-Lo
Control Rod
Tractor
Assembly
Brake Rod, RH
Brake Rod, LH
DH0010
5
3
4
DH0020
3. Instrument Panel
4. Control Lever
5. Handlebar (Left)
Position Handlebar
1. Disconnect Ignition Harness.
2. Position the handlebar right side up.
3. Move the left handle of the handlebar under the
right side of the frame, across the engine and out
between the left side of the frame and the PTO
control.
4. Rotate the handlebar into the mounting position.
5. Reconnect ignition harness.
6. Retain the handlebar in position with four 3/8-16 x
1.25 bolts and locknuts and tighten hardware
(Figure 2).
7. Connect the wiring harness from handlebar to the
unit.
8. Mount the Hi-Lo gear control handle assembly
and pivot to the left handlebar with a 1/2-13 x
3.50 bolt, locknut, and washer (Figure 3).
3
4
5
1. Hi-Lo Control Handle
2. Brake Handle Grip
3. Hi-Lo Control Rod
8
2
6
1
5
4. Extension Rod
5. Adjust and Jam Nuts
6. Left Handlebar
Figure 3
DH0040