Panasonic PT-TW230 Spec File page 11

S F
P E C I L
Short-Throw LCD Projector
Status request commands
Command Description
QPW Standby power status
Q$S Lamp status
QIN
Input signal status
QAV
Volume adjustment value
QPM
Picture mode status
QFZ Freeze status
Q$L Lamp run time
QSH AV mute function status
QKS Keystone correction status
QTE
Color temperature adjustment status
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Parameter format
Parameter format Size (Byte)
3 (1 or 2 bytes also
<pl>
possible when
under control)
1
<off on>
3
<input signal>
3
<power condition>
1
<lamp condition>
4
<acctch>
1
<color temp>
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
Command example
To set the volume to +30, send the command as shown below.
STX
Start
NOTE: When sending commands without parameters, a colon (:) is not necessary.
As of June 2012
SFL12M003-2
E
Standard
Dynamic
Cinema
Real
Blackboard
Colorboard
Image 1
Image 2
Image 3
Image 4
Definition
Decimal without signs: 0 to 999 (000, 001, 002...999)
Decimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)
Callback from the projector is 3 Byte.
0 = off, 1 = on
HD1 = HDMI, RG1 = computer 1, RG2 = computer 2, VID = video,
SVD = S-Video
000 = power off (standby mode off), 001 = power on (standby mode on)
0 = standby, 1 = lamp on under control, 2 = lamp on,
3 = lamp off under control
Decimal without signs: 0000 – 9999 hours
11 = ultra-low, 0 = low, 1 = standart, 2 = high
AVL : 30
Command Parameter
Callback
<Parameter>
<power condition>
<lamp condition>
<input signal>
<pl>
STD
DYN
CIN
REA
BBD
CBD
IM1
IM2
IM3
IM4
<off_on>
<acctch>
<off_on>
<pl>
<color temp>
ETX
End
PT TW230
1 1 / 1 2