Abilia Micro Rolltalk User Manual page 10

14. Select "Finish" to complete
the synchronisation
16. Micro Rolltalk is now connected to the PC, and you can continue installing
software
If you experience connection problems:
1. Disconnect the USB cable and then connect it again. If the two machines will
still not synchronize, reset both the PC and Micro Rolltalk
2. Remove the USB cable, select Start > Settings > Connection > USB to PC
and remove the check mark in front of "Enable faster data synchronization".
Reconnect the USB cable.
3. Connect Micro Rolltalk from the PC by unplugging the USB cable between the
PC and the Micro Rolltalk. Open "Active Sync" on your PC, select File> Delete
Mobile Device and select "OK" in the "Confirm deletion of unity".
Create a new connection to connect Micro Rolltalk to PC via USB cable and
follow the steps 14 to 17 during the installation of Micro Rolltalk for Windows
XP.
17. Go back and restart the Micro Rolltalk installation via the Start Taskbar at the
bottom of the screen or from the open dialog box: "IGEL Micro Rolltalk –
InstallShield Wizard". Follow the instructions on the screen.
15. If the "Hardware Installation"
dialog box appears while you are
installing the Micro Rolltalk CD,
click "Continue anyway".
10
XP