Advertisement
7. All Reset
When affected by static electricity or hard shocks,
watch indications may go wrong. In such a case,
apply an all reset and the following base position
adjustment. All reset is available from the state or
insufficient recharging warning, time setting warning
or power save.
1. Pull the crown twice (time setting position)
• The second hand moves to a zero position it
memorises and stops.
2. Press button
2 seconds or longer and release.
A
• The hour and minute hands perform a
demonstrative movement of "forwarding
reversing
forwarding."
2.
• The second hand makes a full forward turn.
Now all reset is completed. Be sure to make base
position adjustment after all resetting.
If omitted, display positions of watch hands and date
as well as the date changing time may go wrong.
(Note 1) Do not apply all reset during date changing.
Should dislocation occur, pull the crown
once after all resetting, and with button
pressed, turn the crown left and correct the
date position.
(Note 2) The demonstrative movement is not done
when recharging is required. Recharge the
solar cell thoroughly and then do all reset.
8. Base Position Adjustment
After all resetting, adjust the hour and minute hands
by pulling the crown twice and adjust the base
position of date plate by pulling the crown once.
1. With the crown pulled twice, set the hour and
minute hands to 12:00.
A click to the right, the hour and minute hands
1
move forward.
A click to the left, the hour and minute hands
2
move backward.
• A quick right turn rapidly advances the hands
right and a quick turn left rapidly advances them
left. Click the crown through one turn in either
direction to stop rapid advancement.
2. Pull the crown once and adjust the second hand
to 00 second and the date plate to one day.
A click to the right, the second hand moves
1
one second forward.
A click to the left, the date plate moves
2
one day forward.
• A quick left turn rapidly advances the
date. The date stops automatically
after moving through 31 days. Click
the crown through one turn in either
direction to stop rapid advancement.
Indication
Dial
WATER RESIST
or no indication
WR 50 or
WATER RESIST
50
WR 100/200 or
WATER RESIST
100/200
A
Minor exposure to
water (washing
Specifications
face, rain, etc.)
Case
(Case back)
Water-resistant to
WATER
3 atmospheres
RESIST(ANT)
WATER
Water-resistant to
RESIST(ANT) 5
5 atmospheres
bar or WATER
RESIST(ANT)
WATER
Water-resistant to
RESIST(ANT)
10/20
10 bar / 20 bar or
atmospheres
WATER
RESIST(ANT)
3. Return the crown to the normal position and memorise
the base positions of the hands and date plate.
(Note 1) Memory recording of the standard position
takes around one second. When it has
been recorded, the second hand begins
2-second hitch movement. After you
return the crown to its normal position do
not pull the crown out until after 2-second
hitch movement has started.
3.
(Note 2) After all resetting, returning to the normal
position by omitting crown clicking, right
or left, at each of the 1st and 2nd pull
positions does not memorise base
positions, and thus the second hand is
left stopped.
4. After adjusting the base positions, correctly adjust
the time and calendar.
• After setting the standard position, the time
setting will change to 0:00 a.m. Set the time and
calendar with reference to "2. Setting the Time
and Calendar" to avoid confusing a.m. and p.m.
9. Precautions
CAUTION Water-Resistance Performance
There are several types of water-resistance watches,
as shown in the following table. For correct use within
the design limits of the watch, confirm the level of
water-resistance of your watch, as indicated on the
dial and the case, consult the table.
* Water-resistance for daily use (to 3 atmospheres):
This type of watch is water-resistant to minor
exposure to water. For example, you may wear
the watch while washing your face; however it is
not designed for use underwater.
• Upgraded water-resistance for daily use (to 5
atmospheres): This type of watch is water-resistant
to moderate exposure to water. You may wear the
watch while swimming, but it is not designed for
use while skin diving.
• Upgraded water-resistant for daily use (to 10/20
atmospheres): This type of watch may be used for
skindiving; however it is not designed for scuba or
saturated diving such as using helium gas.
Examples of use
moderate
exposure to water
(washing, kitchen,
Marine sports
(skin diving)
work swimming,
etc.)
OK
NO
NO
OK
NO
OK
OK
OK
OK
* WATER RESIST(ANT) xx bar may also be indicated as W.R xx bar.
Saturation diving
Operation of the
Scuba diving
(helium enriched
crown with
(with air tank)
environment
moisture visible
NO
NO
NO
NO
NO
NO
NO
NO
NO
Advertisement
