Table of Contents
Advertisement
Quick Links
CITIZEN QUARTZ
Eco-Drive
Model No. BP1XXX
Cal. No. B872
• INSTRUCTION MANUAL
CTZ-B8028
Please make sure to check the following
before use.
Please read carefully section G entitled "IF YOUR
WATCH IS A DIVER'S WATCH" to ensure proper
use of the watch in the case your watch is a
diver's watch.
If your watch is a diver's watch, the words "AIR
DIVER'S 200M" are indicated on the case back
(or dial).
If the words "AIR DIVER'S 200M" are not
indicated on the case back (or dial) of your
watch, this means that your watch is not a diver's
watch and should not be used for scuba diving.
A. BEFORE USING
This watch is powered not by an ordinary battery,
but by converting photo energy to electrical energy.
Before using, expose to light and make sure
the watch is sufficiently charged.
See "F. TIME REQUIRED FOR CHARGING" for
reference charging times.
A secondary battery is used in this watch to store
electrical energy. This secondary battery is a
clean energy battery which does not use any
toxic substances such as mercury. Once fully
charged, the watch will continue to run for about
6 months without further charging.
To use this watch comfortably, make sure that the
watch is always recharged before it stops.
There is no risk of overcharging this watch.
(Overcharging Prevention Function is provided.)
We recommend that you recharge the watch
every day.
B. SETTING THE TIME AND DATE
* If the crown is of the screw-type, set the time and
date after first loosening the screw. Retighten the
screw after the time and date have been set.
■ Setting the time
1. Stop the second hand at the 0 second position by
pulling the crown out to the 2nd click.
2. Turn the crown to set the time.
3. After setting the time, firmly push the crown back
in to its normal position.
■ Setting the date
1. Pull the crown out to the 1st click.
2. Set the desired date by turning the crown.
• Do not adjust the date when the watch display is
reading between 9:00 pm and 1:00 am, otherwise
the date might not change on the following day.
3. After you have set the date, be sure to firmly
return the crown to its normal position.
Advertisement
Table of Contents
Related Manuals for Citizen Eco-Drive BP1
Summary of Contents for Citizen Eco-Drive BP1
- Page 1 B. SETTING THE TIME AND DATE CITIZEN QUARTZ * If the crown is of the screw-type, set the time and Eco-Drive date after first loosening the screw. Retighten the screw after the time and date have been set. Model No. BP1XXX Cal.
- Page 2 C. FUNCTIONS OF SOLAR POWERED WATCHES If the charge becomes insufficient, a warning function will operate and the display changes as shown below. ■ Insufficient Charge Warning Function The second hand changes to a two second interval movement to indicate insufficient recharge.
- Page 3 D. CARE AND HANDLING DURING CHARGING * The recharging time is the time when the watch is continuously exposed to light. ■ Notes on use Take care to charge your watch during use. Full charge time ..The time to fully recharge after Please note that if you wear long sleeves, the watch the watch has stopped.
- Page 4 [5] Maintaining Water Resistance Please have your watch inspected either through Depth.m N.D. Time your dealer or directly by a Citizen Service Centre (Max. depth (No decompres- every 1 to 2 years to maintain water resistance. in metres)
- Page 5 H. PRECAUTIONS CAUTION: Water-resistance performance There are several types of Examples of use water-resistant watches, as shown in the following table. The unit “bar” is roughly equal to 1 atmosphere. * WATER RESIST (ANT) xx bar may also be indicated as W.R.
- Page 6 • Do NOT leave the watch in a place where it is exposed to high temperature, such as the glove compartment or dash-board of a car. Doing so may result in deterioration of the watch, such as deformation of plastic parts. •...
Need help?
Do you have a question about the Eco-Drive BP1 and is the answer not in the manual?
Questions and answers