Washcare Tips - Hotpoint WD63 Instructions For Installation And Use Manual

STEP 8

Washcare Tips:

Before washing:
Pre-treat stains.
Close zips, tie belts, strings etc...
and press studs to prevent
tangling.
Remove papers or tissues from
pockets.
Remove sharp objects and coins
from pockets as they could cause
damage to clothes or the
appliance.
Limit the size of absorbent loads
ie. towels, to 3kg (7lb) to give
good washing/rinsing results.
Place small items in a wash bag.
Check wash labels as some items
may require a cool programme.
Wash non-colourfast woollens or
really dirty laundry separately as
they may affect other items.
Laundry will not wash properly if
you overload the appliance.
Laundry without a wash label
should not be machine washed.
MY MACHINE MAKES A
NOISE OR VIBRATES IN A
SPIN PROGRAMME.
Check all loose items, such as
coins, have been removed
from the laundry.
Have both transit fixings been
removed from the machine?
Has the polystyrene block been
removed from underneath the
machine?
Have you adjusted the feet to
stabilise the machine?
See STEP 2: Installation
MY LAUNDRY HAS NOT
SPUN DRY.
Was a short spin programme
used on a non-synthetic load.
There has been an
unbalanced load and the machine
could not spin. Redistribute the
clothes by hand and select a spin
only programme.
Did the water pump out?
If not see 'MY MACHINE DOES
NOT PUMP OUT WATER' .
MY MACHINE WILL NOT
START
Close the door. Choose a
programme and then press 'ON'
Does the 'door indicator' light
come on after 2 seconds?
Is the machine plugged in
and switched on?
Is the socket OK? Test with
another appliance to check.
Is the fuse in the plug OK?
Plug the machine in and
turn the socket switch on.
If possible use another socket
for the machine.
If not replace it, see STEP 1:
Electricity Supply
MY MACHINE STOPS
BEFORE A SPIN
PROGRAMME.
The 'Rinse Hold' button has
been pressed, this will hold
laundry in the final rinse water,
until the button is pressed
again.
Troubles
MY MACHINE DOE
PUMP OUT WAT
Has the drain hose bee
correctly?
Are the drainage unit,
or under sink connect
from blockage
Has 'Rinse Hold' been
The light will flash until
is pressed agai
Press the 'Rinse Hold
again.
See STEP 2: Install
Clear any blockages t
been found
Is the machine conne
a sink waste syst
Check the blocked en
under sink drainage
been cut off.
WATER COLLECTS
FABRIC DISPEN
COMPARTMEN
Clean fabric dispense
See STEP 3:'The Dis
Drawer' .