Care And Cleaning Of Refrigerator - GE TFJ20JR Operation Manual

CARE AND CLEANING OF REFRIGERATOR

(1) REFRIGERATOR INTERIOR
Parts that can be removed should be washed. Dry parts before
returning. Use a small amount of mild detergent if needed.
(Detergent should be wiped clean.)
CAUTION: Use mild detergent and warm water to
avoid damaging paint or plastic.
(2) REFRIGERATOR EXTERIOR
Wipe off whenever exterior surfaces are dirty or wet. Apply
suitable wax to the refrigerator exterior several times a year.
(3) DOOR GASKET
The door gasket will deteriorate quickly if liquid food or juice are
spilled on it. Clean the door gasket in the same way as
refrigerator interior.
(4) CONDENSER
Remove front grille when adjusting height of refrigerator or when
cleaning the condenser.
1. To remove the grille, hold the bottom of grille and pull
forward.
2. To install the grille, hold both ends of grille and push prongs
into holes.
Vacuum once or twice a year, since dirt on the condenser will
decrease efficiency, increase electricity consumption, and reduce
cooling capacity of the refrigerator.
(5) REPLACING THE LIGHT BULB
FREEZER COMPARTMENT
Remove the lamp cover before replacing the bulb.
NOTE: On some models, a screw must be removed
before removing the lamp cover.
Grille
Grille
Hole
REFRIGERATOR COMPARTMENT (upper light bulb)
1. Pull out the 2 knobs
or dials.
2. Remove cover by
turning it upward or
by pulling it outward.
3. Turn lamp to the left to
remove and replace it.
4. Use only a 40W bulb.
32
Grille
Prong
Condenser
A B C D E OFF 1 3 5 7 9
Freezer Control
C is Initial Setting
E is Coldest