American DJ INNO BEAM LED User Instructions page 4

Inno Beam LED
NOTICE: The suitable enviromental temperature for this light-
ing fixture is between -25˚ C to 45˚ C. Do not place this lighting
fixture in an enviroment where the temperatures are under or
above the temperatures stated above. This will allow the fixture
to run at its best and help prolong the fixture life.
Screw one clamp via a M12 screw and nut onto the Omega
holder. Insert the quick-lock fasteners of the Omega holder
into the respective holes on the bottom of the Inno Beam LED.
Tighten the quick-lock fasteners fully clockwise. Pull the safety-
cable through the hole on the bottom of the base and over the
trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 7
Mounting Inno Beam LED
Power Supply:
age switch, which will auto sense the voltage when it is plugged into
a power source. With this switch there is no need to worry about the
correct power voltage, this unit can be plugged in anywhere.
DMX-512:
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA "IN" and DATA "OUT" XLR terminals located on all DMX
fixtures (most controllers only have a DATA "OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models
of different manufactures to be linked together and operate from a
single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using
several DMX fixtures try to use the shortest cable path possible. The
order in which fixtures are connected in a DMX line does not influence
the DMX addressing. For example; a fixture assigned a DMX address
of 1 may be placed anywhere in a DMX line, at the beginning, at the
end, or anywhere in the middle. Therefore, the first fixture controlled
by the controller could be the last fixture in the chain. When a fixture
is assigned a DMX address of 1, the DMX controller knows to send
DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation): The Inno Beam LED can be controlled via DMX-512 pro-
tocol. The Inno Beam LED has 2 DMX modes. The DMX address is
set electronically using the controls on the front
panel of the unit. Your unit and your DMX control-
ler require a approved DMX-512 110 Ohm Data
cable for data input and data output (Figure 1). We
recommend Accu-Cable DMX cables. If you are
making your own cables, be sure to use standard
110-120 Ohm shielded cable (This cable may be
purchased at almost all professional sound and
lighting stores). Your cables should be made with
ADJ Products, LLC - www.adj.com - Inno Beam LED Instruction Manual Page 8
The ADJ Inno Beam LED contains a automatic volt-
DMX is short for Digital Multiplex. This is a universal pro-
Set Up
Figure 1