Hotpoint WM51 Instruction Manual page 5

2. Remove Transit Bracket...
Your appliance is fitted with an internal bracket (Fig 1) which prevents damage to the
appliance during transit. Remove parts (Fig 2) following the instructions below.
Note: It is normal for the door seal to look creased, it will not affect its use.
Fig 1
Remove 3 screws from back of
1
work top lid, retain.
3 Remove 1 screw and clamp,
retain.
Slide and push work top lid into
5
position.
Replace work top lid and 3
7
screws.
Transit Bracket
Fig 2
From rear of appliance, grip
2
sides of work top lid, lift, slide
and pull towards you.
4 Remove 2 screws and transit
bracket, retain.
Locate front edge into console.
6
WARNINGS
Before using appliance,
remove transit bracket,
clamp and screws.
Retain parts for future
transportation.
Do not remove
concrete weight.
After removing the
packaging from the
machine, ensure that
the polystyrene
pyramid (shown below)
has come away from the
underside of the
machine, with the
polystyrene base.
If it has not come away,
remove it by tilting the
machine backwards until
the pyramid can be seen
and then remove.
Remember you may be
charged for a service call if a
problem with your
appliance is caused by
incorrect installation or
misuse.
5