Connecting Other Equipment; Troubleshooting Chart - Sharp GX-BT3 Operation Manual

Connecting other equipment

■ Listening to the playback sounds of
portable audio player, etc.
Portable audio
Audio cable (not supplied)

Troubleshooting chart

Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the fol-
lowing before calling your authorised SHARP dealer or
service centre.
■ General
Symptom
 When a button is
pressed, the unit
does not respond.
 No sound is heard.
■ Remote control
Symptom
 The remote control
does not operate.
GX-BT3
player, etc.
Possible cause
 Set the unit to the power
standby mode and then
turn it back on.
 If the unit still malfunctions,
reset it. (Refer page 10)
 The volume level is set to
minimum.
Possible cause
 The AC power lead of the
unit is not plugged in.
 The battery is exhausted.
 The distance or angle is
incorrect.
 The remote control sensor
receives strong light.
1 Use a connection lead to plug in the portable audio
player, etc. to the AUDIO IN socket. When using video
equipment, plug in the audio output to this unit and the
video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on the main unit to select
AUDIO IN function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may oc-
cur. Should this happen, lower the volume of the con-
nected device. If volume level is too low, increase the
volume of the connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ NFC / Bluetooth
Symptom
● No sound is heard.
● Bluetooth sound
is interrupted or
distorted.
● NFC-enabled device
cannot connect to
Bluetooth via NFC tag.
E-9
Possible cause
● The unit is too far from the
Bluetooth stereo audio
source device.
● The unit is not paired
with the Bluetooth stereo
audio source device.
● The unit is too near to
a device that generates
electromagnetic radiation.
● There is an obstacle
between the unit and the
Bluetooth stereo audio
source device.
● Main unit is not in
Bluetooth pairing mode.
Perform "NFC connection
for audio playback".
(Refer page 6.)