Miele Dishwasher Operating Instructions Manual page 46

Dishwasher installation
3. Installing the control panel.
The control panel and hardware is
packaged separately from the dish-
washer. It should be installed using the
following procedure.
If the GDU decor set is being used,
(to convert an "i" dishwasher to a "U"
version), the spacer bars
be removed and stored for possible
use in the future, (See the separate in-
structions for installing the GDU
decor set). If the GDU kit is not being
used, skip the following step.
To remove the spacer bars from the
control panel, place the panel on a
table, printed side up, and gently
push down on the spacer bars at a
46
i
must first
point near the bottom of the control
panel. This will release the mounting
bolts from their slots.
Install the necessary spacer bars
on the control panel.
b
Place the seal
c
grill.
Push the ventilation grill
metal backing plate.
Place the covers
button switches.
Install the adapter disc e.
Position the control panel
backing plate and fasten it from the
inside of the door
screws provided.
Align and press the program knob
h
onto its shaft .
i
onto the ventilation
c
into the
d
over the push-
f
over the
g
using the six