Advertisement
2
To Troubleshoot This
Issue
My footrest will not
raise/lower.
My footrest is
physically bent/broken.
My memory buttons
don't work.
When I press the PRO
Mode button nothing
happens (other than
the blue LED lights).
My headrest falls off
when I recline all the
way into Pro Mode.
My chair wobbles
slightly/sits uneven.
Do the following:
If the footrest will not raise/lower at all, replace
the footrest actuator.
If that does not solve the problem, do one of
the following:
• For serial numbers CWC24130001 -
CWC24130078, replace both the control
panel and the main control module w/power
cord.
• For all other serial numbers, replace the
control panel.
Replace the footrest scissor assembly.
Verify that you are using the memory buttons
as described in the Use & Care manual.
f that does not solve the problem, do one of the
following:
• For serial numbers CWC24130001 -
CWC24130078, replace both the control
panel and the main control module w/power
cord.
• For all other serial numbers, replace the
control panel.
Pressing the PRO button enables you to recline
the chair beyond the ZeroG position. However,
the chair does not automatically recline.
Use the control panel recline and incline
buttons to recline to the desired position.
Your chair came with two headrest screws and
an Allen wrench, contained in a plastic bag
along with your Use & Care manual and other
documentation.
Follow the assembly instructions in the Use &
Care manual to properly install the headrest,
using the two screws to secure it.
Carefully check underneath to determine if one
of the four plastic feet is broken/missing. If so,
replace the plastic foot (spare part contains a
set of four).
If your chair is on an uneven floor, you can
adjust the plastic feet to compensate.
PCX-720 Troubleshooting Guide
Advertisement
