Product Data; Condenser Unit - Hotpoint TCUD 97B Instruction Booklet

Important Information

Condenser Unit...

! You MUST clean the fluff from the condenser EVERY
month.
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
Rotate 3 clips
Product Data... (EU Regulation 392/2012)
Rated capacity of Cotton laundry for the standard programme at full load 9 kg
The weighted Annual Energy Consumption (AE
Consumption per year, based on 160 drying cycles of the standard cotton programme at full and partial load, and the
consumption of the low-power modes. Actual energy consumption per cycle will depend on how the appliance is used.
This household tumble dryer is an Automatic Condenser Dryer
Energy consumption : full load E
Power consumption : off-mode (P
Duration of the 'left-on mode' for power management systems 30 minutes
The 'standard cotton programme' suitable for drying normal wet cotton laundry that is the most efficient programme in
terms of energy consumption for cotton used at full and partial load is Cottons - Cupboard Dry (with the dryer
plumbed into a drain).
Programme time (minutes) : weighted (T
Condensation efficiency class B
Average condensation efficiency (%) : full load (C
Airborne acoustical noise emissions 69 dB(A) re 1 pW
This data is also available on the website
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal).
Check that:
●
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their 'lock' position.
! Failure to clean the condenser could cause premature
failure of your dryer.
) 616.1 kWh
c
5.22 kWh, partial load E
dry
) 0.17 W, left-on mode (P
o
) full & partial load 114, full load (T
t
) 84, partial load (C
dry
http://www.hotpoint.eu/hotpoint/
STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits.
Energy efficiency class B
2.81 kWh
dry1/2
) 3.27 W
l
) 153, partial load (T
dry
) 84, weighted (C
dry1/2
STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
) 85
dry1/2
) full & partial load 85
t
3
GB