Setup Instructions - Harbor Freight Tools 96755 Set Up And Operating Instructions Manual

read the entire iMpOrtant saFety inFOrMatiOn section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
1. Push the End Clip forward and down to release the Staple Channel Latch. Pull
out the Staple Channel-see Figure 1.
2. Load the staples or brad nails into the Staple Channel. Each of the fasteners is
to be loaded into the Staple Channel with its sharp end facing the base of the
Staple Channel-see Figure 2.
Staples are to be inserted into the center of the Staple Channel as shown in
Figure 2. Brad nails are to be inserted on either side of the Staple Channel, as
in Figure 2, but not placed in the center of the Staple Channel.
SKU 96755
set up instructiOns
loading the staples
Figure 1
Standard
staple
For technical questions, please call 1-800-444-3353.
Push in and down to release the
Staple Channel Latch.
Figure 2
U-Shaped
staple
Brad
Page 5