Installation - Kenwood KSC-SW11 Instruction Manual

Installation

Before fixing the speaker in its position, be sure to check the sound while it is connected preliminary.
Caution:
• When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on
the opposite side such as a gasoline tank, brake pipe; or wiring harness, and be careful not to cause scratches or other damage.
• Install in a location that does not come in the way of driving, getting in or out of the vehicle and movement inside the ve-
hicle compartment.
• Fix the product firmly so that it will not be moved by vibrations or impacts during driving.
■ Fixing the cord in place
8 Machine screw x 2
5 Fixture B
1 Remote control
2 10-pin connector cord
■ Fixing the subwoofer
The subwoofer can be fixed in two ways. Select the optimum attaching position of fixture A 4 according to the subwoofer
installation location.
Fixing method A
1
Attach the fixtures A 4 to the speaker unit securely
using the machine screws 7 . Be careful so that the
connected cords do not get in between the speaker
unit and fixtures A 4 .
2
Drill the pilot holes for ø 3.6 mm screws on the sheet
metal section of the vehicle , and attach the speaker
unit to the vehicle using the tapping screws 6 .
6
English
4 4 Fixture A
7 Machine screw x 4
4 Fixture A x 2
Caution:
This por tion becomes
slightly hotter than other
portions because it func-
tions as the radiator of
the heat generated by
the amplifier.
6 Tapping screw x 4
Drill four pilot holes for
ø 3.6 mm screws.
Connect the 10-pin connector cord 2 and remote
control 1 to the speaker unit.
Fix the cords to the speaker unit with fixture B 5 and
fix in place with the machine screws 8 .
Prohibition!
Fix the cord so that it will not
protrude from the side of the
p speaker unit.
Fixing method B
1
7 Machine screw x 4
Attach the fixtures A 4 to the speaker unit securely
using the machine screws 7 . Be careful so that the
connected cords do not get in between the speaker
unit and fixtures A 4 .
2
6 Tapping screw x 4
Drill four pilot holes for
ø 3.6 mm screws.
Drill the pilot holes for ø 3.6 mm screws on the sheet
metal section of the vehicle , and attach the speaker
unit to the vehicle using the tapping screws 6 .
4 4 Fixture A
4 Fixture A x 2
Caution:
This por tion becomes
slightly hotter than other
portions because it func-
tions as the radiator of
the heat generated by
the amplifier.