Table of Contents
Advertisement
50
Replacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the
lamp.
The projector will detect the lamp life. You will be shown a warning message
"
as possible. Make sure the projector has been cooling down for at least 30
minutes before changing the lamp.
before changing the lamp.
To Change the Lamp
1
Turn off the projector by pressing the power button.
2
Allow the projector at least 30 mins to cool down.
3
Disconnect the power cord.
4
Remove the two screws on both sides of the projector at the same time.
(Illustration #1)
5
Push and slide the top cover towards the direction of the lens. (Illustration #2)
6
Open the top cover. (Illustration #3)
7
Remove the two screws that secure the lamp module
lamp bar .(Illustration #4)
8
Pull out the lamp module by force. (Illustration #5)
To replace the lamp module, reverse the previous step.
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
" When you see this message, change the lamp as soon
The lamp compartment is hot! Allow it to cool down
1
5
To reduce the risk of personal injury, do not drop the
2
1
2
4
and pull up the
3
Hide quick links:
Advertisement
Table of Contents
