Trouble Shooting - Yard-Man 989 Series Operator's Manual

For Parts Call 606-678-9623 or 606-561-4983 For Parts Call 606-678-9623 or 606-561-4983
6
Trouble
Shooting
For repairs beyond
the minor adjustments
listed here, contact
an authorized service
dealer.
Problem
Engine fails to start
1. Blade control disengaged.
2. Spark plug wire disconnected.
3. Fuel tank empty or stale fuel.
4. Fuel valve closed.
5. Faulty spark plug.
6. Blocked fuel line.
7. Engine flooded.
Engine runs erratic
1. Spark plug wire loose.
2. Blocked fuel line or stale fuel.
3. Vent in gas cap plugged.
4. Water or dirt in fuel system.
5. Dirty air cleaner.
6. Carburetor out of adjustment.
Engine overheats 1. Engine oil level low.
2. Air flow restricted.
3. Carburetor not adjusted properly.
Occasional skips
1. Spark plug gap too close.
2. Carburetor idle mixture adjustment
(hesitates) at
high speed
1. Spark plug fouled, faulty, or gap
Idles poorly
2. Carburetor improperly adjusted.
3. Dirty air cleaner.
Excessive
1. Cutting blade loose or unbalanced.
Vibration
2. Bent cutting blade.
Mower will not
1. Wet grass.
mulch grass (If
2. Excessively high grass.
Equipped)
3. Dull blade.
Uneven cut 1. Wheels not positioned correctly.
2. Dull blade.
Mower will not
1. Belt not installed properly.
self propel
2. Debris clogging drive operation.
3. Damaged or worn belt.
www.mymowerparts.com www.mymowerparts.com
Cause
improperly set.
too wide.
14
Remedy
1. Engage blade control.
2. Connect wire to spark plug.
3. Fill tank with clean, fresh gasoline.
4. Open fuel valve. See engine manual.
5. Clean, adjust gap, or replace.
6. Clean fuel line.
7. Wait a few minutes to restart.
1. Connect and tighten spark plug wire.
2. Clean fuel line; fill tank with clean,
fresh gasoline.
3. Clear vent.
4. Drain fuel tank. Refill with fresh fuel.
5. Refer to engine manual.
6. Refer to engine manual.
1. Fill crankcase with proper oil.
2. Remove blower housing
and clean.
3. Refer to engine manual.
1. Adjust gap to .030".
2. Refer to engine manual.
1. Reset gap to .030" or replace
spark plug.
2. Refer to engine manual.
3. Refer to engine manual.
1. Tighten blade and adapter. Balance
blade.
2. See an authorized service dealer.
1. Do not mow when grass is wet; wait
until later to cut.
2. Mow once at a high cutting height,
then mow again at desired height or
make a narrower cutting path.
3. Sharpen or replace blade.
1. Place all four wheels in same
height position.
2. Sharpen or replace blade.
1. Check belt for proper pulley installation
and movement.
2. Stop engine, disconnect spark plug
wire, and clean out debris.
3. Inspect and replace belt.