Table of Contents
Advertisement
Design type D
Dual conductor
End cap
Heating cable length
Design type e
Dual conductor
The joints can be either brazed or laser welded, refer to Pentair Thermal
Management product literature for more detailed information.
please note that this manual only covers the installation of pre-
fabricated mi heating units. The complete termination process and
repair of heating cable units is not covered by this manual and must be
carried out by qualified and experienced personal only.
For more information contact your Pentair Thermal Management
representative.
important
for the pentair Thermal management warranty to apply, the
instructions of this manual must be followed. Design, installation,
inspection, operation and maintenance must be in accordance with the
standards ieC 60519,
ieC 62086, en 50019 and en60079-7 (where applicable). other local
requirements and national electric codes applicable to electrical heat-
tracing systems must be followed as well. The thermal safety class is 2
(to ieC 60519-2).
Personal involved in the installation, testing and maintenance of electric
heat-tracing systems must be suitably trained in all special techniques
required, as well as in general electrical installation work. All work
should be monitored by supervisors experienced in heat-tracing
applications.
Hot/cold joint
Hot/cold joint
Heating cable length
Cold lead cable
(standard 2 m)
Gland
Cold lead cable
(standard 2 m)
Gland
Potted seal
Potted seal
300 mm
Flexible
tail length
300 mm
Flexible
tail length
5
Advertisement
Table of Contents
